5.6
Firewall Settings
Set the firewall for each service. The settings are required respectively for the MNT port and the RMT port.
•
If both HTTP connection and HTTPS connection are disabled, the device is inaccessible via ETERNUS Web
GUI.
•
If both Telnet connection and SSH connection are disabled, the device is inaccessible via ETERNUS CLI.
•
Some functions cannot be used if the ETERNUS DX Discovery function is enabled for the MNT port. Make
sure to disable the ETERNUS DX Discovery function in "Firewall Setting".
1
Start the Web browser and log in to ETERNUS Web GUI with the IP address that is set in
"5.4 Storage Management (Initial Setup 1)" (page 77)
.
2
Click the [System] tab on the navigation of the ETERNUS Web GUI screen.
3
In [Category], click [Network].
The [Network] screen appears.
4
Select the port to be set. In [Action], click [Firewall Setting].
Chapter 5 General Settings
5.6 Firewall Settings
86
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
Summary of Contents for ETERNUS DX100 S3
Page 2: ...This page is intentionally left blank ...
Page 188: ......
