Fujitsu ETERNUS DX100 S3, Configuration Manual

Page: 72 / 188

●
ETERNUS DX Disk Storage System Environment
Create the operation volume and backup volume in the ETERNUS DX Disk storage system.
Figure 5.2 Example of Creating Operation Volume and Backup Volume
ETERNUS DX Disk storage system
RAID group 0 (RAID5)
600GB 5
RAID group 1 (RAID5)
2TB 3
Standard
Snap Data Volume (SDV)(*1)
Snap Data Pool Volume (*2)
1TB
500GB
Backup volume
Operation volume
Backup temporary work volume
sdv0
sdpv
main
sdv1 sdv2 sdv3 sdv4 sdv5 sdv6
*1: SDV is used as the copy destination for and stores generation data.
*2: SDPVs are volumes that configure the SDP. The SDP is used to assign an area to an SDV when the SDV
capacity is insufficient. When SDPVs are not required, they are automatically released and restored to
their original status.
5.1 PC Terminal Connection
Connect a PC terminal to the ETERNUS DX Disk storage system.
Connect the PC terminal to the RMT port of Controller 0 (CM#0) on the controller enclosure directly with the
LAN cable (for operation management).
For the setup information of the PC terminal, refer to
"3.3 Preparing the PC Terminal for Setup" (page 50) .
Chapter 5 General Settings
5.1 PC Terminal Connection
72
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0