Fujitsu ETERNUS DX S2, ETERNUS DX S3, ETERNUS DX S4, ETERNUS AF, Configuration Manual

Page: 16 / 29

Chapter 4 Set Up the ETERNUS DX/AF Storage System for BS2000
4.2 Configuring Settings for the Fibre Channel Ports (CA Parameters)
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection-
Copyright 2018 FUJITSU LIMITED P3AM-5672-10ENZ0
16
For each connection configuration, set the indicated items.
Table 4.1 FC-AL connection settings (Host-direct-connection)
- not for SE Server (SU /390) and S-Servers, not for ETERNUS DX8700 S3!
*1: Set the appropriate value from the following table. Do not use [8G/4G/2Gbit/s Auto].
Table 4.2 Fabric connection settings (Host-Fabric-connection)
*1: Set the appropriate value from the following table. Do not use [8G/4G/2Gbit/s Auto].
Parameter BS2000
Connection Topology FC-AL Connection
Loop-ID (Manual) 0x00
FC Frame Size 2048 byte (Default value)
Transfer Rate See the table below (*1)
Affinity Mode (ON)
Reset Scope T_L
Reserve Cancel at Chip Reset ON / Enable
Fibre Channel switch maximum speed ETERNUS DX/AF storage system CA type
32Gbit/s CA 16Gbit/s CA 8Gbit/s CA
16Gbit/s 16Gbit/s 16Gbit/s 8Gbit/s
8Gbit/s 8Gbit/s 8Gbit/s 8Gbit/s
4Gbit/s — 4Gbit/s 4Gbit/s
2Gbit/s — — 2Gbit/s
Parameter BS2000
Connection Topology Fabric Connection
FC Frame Size 2048 byte (Default value)
Transfer Rate See the table below (*1)
Affinity Mode (ON)
Reset Scope T_L
Reserve Cancel at Chip Reset ON / Enable
Fibre Channel switch maximum speed ETERNUS DX/AF storage system CA type
32Gbit/s CA 16Gbit/s CA 8Gbit/s CA
16Gbit/s 16Gbit/s 16Gbit/s 8Gbit/s
8Gbit/s 8Gbit/s 8Gbit/s 8Gbit/s
4Gbit/s — 4Gbit/s 4Gbit/s
2Gbit/s — — 2Gbit/s