Fujitsu ETERNUS DX S2, ETERNUS DX S3, ETERNUS DX S4, ETERNUS AF, Configuration Manual

Page: 15 / 29

Chapter 4 Set Up the ETERNUS DX/AF Storage System for BS2000
4.2 Configuring Settings for the Fibre Channel Ports (CA Parameters)
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection-
Copyright 2018 FUJITSU LIMITED P3AM-5672-10ENZ0
15
4.2 Configuring Settings for the Fibre Channel Ports
(CA Parameters)
TPGS Mode Enable (Default)
Sense Data Conversion No Conversion (Default)
Parameter BS2000
Please be aware that only a homogeneous sharing with other BS2000 Servers is supported for FC Ports which
are connected to a BS2000 server. The combine Port Mode CA/RA is not supported by ETERNUS DX S2, but
tolerated as of ETERNUS DX S4/S3 and ETERNUS AF.
Note: In these terms the Management Unit (MU) and the Server Unit (SU x86) of an SE Server, resp. the
Server Unit of an SQ-Server are considered to be a BS2000 server, irrespective of whether Linux/Windows
guests are running or not on the Server Unit. The Application Unit of an SE Server /SQ-Server is a non-BS2000
server.
When setting a Fabric connection, complete the preparation work and set up the Fibre Channel switch
beforehand.
For further details, refer to "ETERNUS DX/AF Storage Systems Server Connection Guide (Fibre Channel) Fibre
Channel Switch Settings Administrator’s Guide".
Controller Category Action
DX/AF series Connectivity > Port Group > FC Configure FC Port