Fujitsu ETERNUS CS800 S6, User Manual

Page: 223 / 561

10.3 VTL Configuration
Target Select the target (port) to associate with the group.
The Backpanel Locations section displays a graphical
representation of the Fibre Channel and Ethernet
ports as they appear on the rear of the system. A
dark border displays around the currently selected
target.
If a target is directly connected to the ETERNUS
CS800, only the directly connected ports are
displayed. Otherwise, all ports are displayed.
3. (Optional) Select the Use CCL check box to use the Command and Control LUN.
The CCL (Command and Control LUN) is not used in most environments. This
option is recommended for host access groups that contain an HP-UX host.
It can also be used if hosts that are not assigned to any host access group
exist in the SAN. The CCL is accessible to hosts only through LUN 0.
CAUTION!
If you are not sure if you should use CCL, contact Fujitsu Technology Solutions
Customer Support before you enable this option.
4. Select the check boxes for the media changer and tape drives to add to the host access
group.
The LUN assignment displays next to the device.
5. Click Apply .
Editing a Remote Host Access Group
Edit a host access group to change the CCL setting. You can also add or remove virtual
media changers or tape drives.
To edit a host access group:
1. Select the group and click Edit .
The Edit Remote Host Mapping page displays (see "Edit Remote Host Mapping Page"
on page 224 ).
If you are editing a host access group, you cannot change the Group Name ,
Partition , Host , or Target .
ETERNUS CS800 223