1.1.3
Components (Front)
This section describes the operation panel and the batteries in the front of the controller enclosure.
■
Operation Panel
An operation panel has LEDs, a Power switch, and setting change switches.
shows the status and meanings of each LED.
Figure 1.4 Operation Panel (Controller Enclosure)
2
3
1
4
6
5
8
7
A
B
9
11
10
A.
With a flange cover
B.
Without a flange cover and a front cover
1.
Power switch
This switch is used to turn on or off the ETERNUS AF.
2.
POWER LED
3.
IDENTIFY LED
4.
FAULT LED
5.
MAINTENANCE LED
6.
CACHE LED
7.
READY LED
8.
REMOTE LED
9.
MNT SW (maintenance switch)
This switch is used to switch the maintenance status on or off.
10. IP RST SW (IP reset switch)
This switch is used to initialize the LAN ports or to initialize the user information.
11. MST SW (CM Master Change switch)
This switch is used to change the Master CM.
Chapter 1 Component Names and LED Names
1.1 Controller Enclosures
14
FUJITSU Storage ETERNUS AF650 S2, ETERNUS AF650 All-Flash Arrays Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AG-1932-04ENZ0
Summary of Contents for ETERNUS AF650 S2
Page 2: ...This page is intentionally left blank ...
Page 59: ......