Fujitsu AOTG30KMTC, Service Manual, Page: 73 / 199

2-22. E: 65. IPM error (Outdoor unit)
Indicator
Indoor unit
Operation indicator 6 time flash
Timer indicator 5 time flash
Economy indicator Continuous flash
Error code E: 65
outdoor unit
Refer to “Error code table (Outdoor unit: for 34 model
only)” on page 1
Detective actuator Outdoor unit
Main PCB 1. When more than normal operating current to IPM in
main PCB flows, the compressor stops.
2. After the compressor restarts, if the same operation
is repeated within 40 seconds, the compressor
stops again.
3. If 1. and 2. repeats 5 times, the compressor stops
permanently.
Compressor
Forecast of cause Defective connection of electric components
Outdoor fan operation failure
Outdoor heat exchanger clogged
Compressor failure
Transistor PCB failure
Main PCB failure
Check point 1. Check connections of outdoor unit electrical components
• Check if the terminal connection is loose.
• Check if connector is removed.
• Check erroneous connection.
• Check if cable is open.
→ Upon correcting the removed connector or mis-wiring, reset the power.
↓
Check point 2. Check outdoor fan and heat exchanger
• Is there anything obstructing the air distribution circuit?
• Is there any clogging of outdoor heat exchanger?
• Is the fan rotating by hand when operation is off?
→ If the fan motor is locked, replace it.
↓
Check point 3. Check outdoor fan
Check outdoor fan motor. (Refer to "E: 97. Outdoor unit fan motor error (Outdoor unit)" on page 03-
46.)
→ If the fan motor is failure, replace it.
↓
2-22. E: 65. IPM error (Outdoor unit)
- (03-35) -
2. Troubleshooting with error code
TROUBLESHOOTING TROUBLESHOOTING