Fujitsu 4340C - fi - Document Scanner, Operator'S Manual

Page: 67 / 114

●
7-3
This section describes the contents of the setup mode.
No Item Description
Selectable
parameters
Default
1
Double feed check
Specifies the double feed detection.
Double feed is detected by checking the
document length and/or paper
thickness.(*1)
No/Yes No
2
Length check
=No/10/15/20 mm
Specifies the document length to enable
double feed detection sets the document
length.
Tolerance:
No/10/15/20mm
No
3
IPC pre-setting
Scanner automatically sets the
recommended reading parameters. 3 sets
of parameters are available when IPC-4D
is not installed.
Document:
No
1: Sharpen
2: Darken Character
3: Copy Quality
No
4
Resetting of
abrasion counter
Resets the abrasion counter. --- ---
5
Pick start time
setting
Specifies the time from document Insertion
to the start of picking. User can select the
most comfortable Pick start time for the job.
Time:
0.2 to 29.8 sec
1.0 sec
6
Time-out limit setting
Specifies the time the scanner waits for
the next document insertion after the last
document was scanned. Time:
27 values from
1 to 1999 sec
30 sec
7
ADF front offset
setting(*2)
Specifies the horizontal and vertical offset
of the front side image when using the
ADF. Offset:
H:-2 to +3 mm
V:-2 to +3 mm Offset:
H: 0 mm
V: 0 mm
8
ADF back offset
setting(*2)
Specifies the horizontal and vertical offset
of the back side image when using the
ADF. Offset:
H:-2 to +3 mm
V:-2 to +3 mm Offset:
H: 0 mm
V: 0 mm
9
Document bed
offset setting(*2) Horizontal and vertical offset of the FB
image is specified.
Offset:
H:-2 to +3 mm
V:-2 to +3 mm Offset:
H: 0 mm
V: 0 mm
10
IPC status display
Displays whether or not the image
processing board (IPC-4D) and the
Imprinter option are installed.
--- ---
11
Low Power Mode
setting Changes the default setting of the duration
for power save. 5 min.
to 60 min.
15 min.
12
Select Interface
Selects the interface when the scanner
has a board in the third party Slot.
Auto/SCSI/Tps Auto
13
Display TPS Board
ID Number Displays the ID number of the board which
is installed in the third party Slot.
--- ---
Contents of the Setup Mode