EN-8
ENGLISH
Changes and Additions
Flash Function Setting
Flash Function Setting
X-T1 Owner’s Manual
:
P
81
A
FLASH FUNCTION SETTING
option has been
added to the shooting menu.
FLASH FUNCTION SETTING
FLASH FUNCTION SETTING
Choose a fl ash control mode, fl ash mode, or sync mode
or adjust the fl ash level. The options available vary with
the fl ash.
Option
Option
Description
Description
SYNC
SYNC
TERMINAL
TERMINAL
Available with units connected via the sync ter-
minal and with third-party and other units that
use only the X-contact on the hot shoe. Also dis-
played if no fl ash unit is connected (
EN-8
).
SUPPLIED
SUPPLIED
FLASH
FLASH
Displayed when the supplied EF-X8 fl ash unit is
mounted on the hot shoe and raised (
EN-9
).
SHOE MOUNT
SHOE MOUNT
FLASH
FLASH
Displayed when an optional fl ash unit is mount-
ed on the hot shoe and turned on (
EN-10
).
MASTER
MASTER
(OPTICAL)
(OPTICAL)
Displayed if an optional fl ash unit functioning
as a master fl ash for FUJIFILM optical wireless re-
mote fl ash control is connected and turned on
(
EN-11
).
R
SYNC TERMINAL
will also be displayed if the fl ash is at-
tached but not raised.
■
SYNC TERMINAL
The following options are
available when a fl ash unit is
connected via the sync ter-
minal.
MODE
SYNC TERMINAL
ADJUST
END
A
Flash control mode
: Choose from the options below.
•
M
: A trigger signal is transmitted from the sync terminal
and hot shoe when a picture is taken. Choose a shutter
speed slower than the sync speed (1/180 s); even slower
speeds may be required if the unit uses long fl ashes or
has a slow response time.
•
OFF
: The sync terminal and hot shoe do not transmit a
trigger signal.
B
Sync
: Choose whether the fl ash is timed to fi re immediately
after the shutter opens (
1ST CURTAIN
) or immediately be-
fore it closes (
2ND CURTAIN
).
1ST CURTAIN
is recommended in
most circumstances.
The Sync Terminal
The Sync Terminal
Use the sync terminal to connect
Use the sync terminal to connect
fl ash units that require a sync cable.
fl ash units that require a sync cable.