36
4. SETUP AND MAINTENANCE
4
4. Click the [Auto Correct] button.
• The mask position is corrected automatically and the
correct vertical and horizontal values are displayed in
the “Position Adjust” boxes.
5. Adjust mask position if necessary by clicking the arrow
buttons while checking the adjustment values indicated at the
right-hand side of and below the arrow buttons.
NOTE: The mask position is returned to the “0.0 mm”
position if the [Initialize] button is clicked.
6. Click the [Regist.] button.
7. Repeat Steps 1 to 6 for all masks to be used.
8. Click the [Close] button.
• Operation returns to the menu screen.
4.5.3 NC100AY Input Check (0421)
The status of each sensor of the auto film carrier NC100AY can
be checked.
Install the auto film carrier NC100AY before performing the steps
on this menu.
[Selection]
[Setup and Maintenance]
→
[04 Carrier Adjustment/
Maintenance]
→
[0421 NC100AY Input Check]
[Procedure]
Check the current status of the sensors.
1. Click the [Next] button.
2. Click the [Next] button.
3. Click the [Close] button.
• Operation returns to the menu screen.
4.5.4 MFC10AY Input Check (0422)
The status of each sensor of the multi-film carrier MFC10AY can
be checked.
Install the multi-film carrier MFC10AY before performing the steps
on this menu.
[Selection]
[Setup and Maintenance]
→
[04 Carrier Adjustment/
Maintenance]
→
[0422 MFC10AY Input Check]
[Procedure]
Check the current status of the sensors.
1. Click the [Close] button.
• Operation returns to the menu screen.
4.5.3
4.5.4
SP3000_instruct_E.book 36 ページ ２００７年１２月１１日 火曜日 午後１時６分
