FujiFilm SONOSITE X-PORTE, User Manual

Page: 16 / 366

2-6 Getting started
To connect a USB memory stick for importing or exporting

Insert the USB memory stick into a USB port (see “About the system” on page 2-1).
The USB memory stick is ready when the USB icon appears onscreen.
To view information about the device, see “USB settings” on page 3-36.
To disconnect a USB memory stick
Disconnecting the USB memory stick while the system is exporting to it may cause the exported files to be
corrupted or incomplete.
1 If exporting, wait at least five seconds after the USB animation icon stops.
2 Remove the USB memory stick from the port.
General interaction
Clinical monitor
Cautions

To avoid damaging the USB memory stick and losing patient data from it, observe
the following:

Do not remove the USB memory stick or turn off the ultrasound system
while the system is exporting.

Do not bump or otherwise apply pressure to the USB memory stick while it is
in a USB port on the ultrasound system. The connector could break.

If the USB icon does not appear in the system status area on the clinical
monitor, the USB memory stick may be defective or software-encrypted.
Replace the USB memory stick.
WARNINGS

FUJIFILM SonoSite does not recommend using a monitor other than the clinical
monitor provided by FUJIFILM SonoSite. Only the images presented on the
clinical monitor are validated for the intended use of the device.

Do not use a monitor connected through the external VGA or digital video out
for medical diagnosis.