FujiFilm SonoSite SII, User Manual Supplement

Page: 20 / 476

18 Measurements and calculations
3 Tap Manual .
A single caliper appears.
4 Using the touchpad or the touchscreen, position the caliper at the beginning of the desired waveform,
and then tap to activate the trace.
5 Using the touchpad or the touchscreen, trace the waveform, and then tap Set or .
To make a correction, tap Undo or Delete .
To perform automatic trace measurements in Doppler
1 On a frozen Doppler spectral trace, tap Calipers .
2 Navigate to the second page by tapping the arrow.
3 Tap Auto .
A vertical caliper appears.
4 Using the touchpad or the touchscreen, position the caliper at the beginning of the desired waveform,
and then tap .
A second vertical caliper appears.
5 Using the touchpad or the touchscreen, position the caliper at the end of the desired waveform, and then
tap
Set .
To make a correction, tap Undo or Delete .
Automatic trace results
Depending on the exam type, the results from automatic tracing include the following:
WARNING
When using the touchpad to trace a shape, be careful not to touch until you
are finished with the trace. Doing so may complete the trace prematurely, causing
an incorrect measurement and delay of care.

Velocity Time Integral (VTI)

Cardiac Output (CO)

Peak Velocity (Vmax)

Peak Systolic Velocity (PSV)

Mean Pressure Gradient (PGmean)

Time Average Mean (TAM)

Mean Velocity on Peak Trace (Vmean)

+/x or Systolic/Diastolic (S/D)