FujiFilm PXG4, Operation Manuals

Page: 88 / 158

– 87 –
8
Chapter
AO Lower Limit Scaling ,
AO Upper Limit Scaling
This is the procedure for specifying the upper and lower
limits of re-transmission input.
• Range: -100% to 100% FS (Upper/lower limit)
Calculate the set value with the following equation. (Use the
example set value below as a reference.
Set value (%) = (A ÷ B) x 100 [%]
A = (Desired temperature) – (Set value of parameter "
PPP
PVVVVbbbb
")
B = (Set value of parameter "
PPP PVVVVFFFF
") – (Set value of "
PPP PVVVVbbbb
")
• When the value of the re-transmission output type (ex: SV)
is equal to the AoL set value, the re-transmission output
will be 0% (output).
• When the value of the re-transmission output type (ex: SV)
is equal to the AoH set value, the re-transmission output
will be 100% (output).
Setting AO Upper/Lower Limit Scaling
The following steps explain how to set AO limit scaling by
using -80% to 80% as an example.
Caution
Make sure to set the value of AoH greater than AoL.
re-transmission output
calculated value
actual re-transmission output
100%
scaling range
upper/lower limit
–100%
100%
–100%
80% (AoH)
–80% (AoL)
1
Press and hold the key to display the setup
mode channel menu ("
ooo oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display SET ("
SSS
SEEEETTTT CCCChhhh 6666
").
Refer to
See p. 74 in this chapter for information on how to display
the operation menu.
2
Press and hold the key, then use the
keys to select AoL ("
AAA AooooLLLL
").
3
Press the key, then use the keys to
select -80 when the bottom part of the display
begins to blink.
The AO lower limit is set to "-80%".
4
Press the key to confirm the setting.
5
Repeat steps 2 to 4 (excluding pressing and
holding the key) to set the AO upper limit
("
AAA
AooooHHHH
") to 80%.
6
Press the key to return to the operation mode
PV/SV display.