FujiFilm PXG4, Operation Manuals

Page: 86 / 158

– 85 –
8
Chapter
Standby OUT1 Output ,
Standby OUT2 Output
This is the procedure for setting the OUT1/OUT2 values
for standby mode.
• Range: -3.0% to 103.0% (OUT1/OUT2)
Setting Standby Mode OUT1/OUT2 Output
The following steps explain how to set Standby Mode OUT1/
OUT2 by using 5% as an example.
1
Press and hold the key to display the setup
mode channel menu ("
ooo
oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display SET ("
SSS SEEEETTTT CCCChhhh 6666
").
Refer to
See p. 74 in this chapter for information on how to display
the operation menu.
2
Press and hold the key, then use the
keys to display Sbo1 ("
SSS Sbbbboooo1111
").
3
Press the key, then use the keys to
select 5.0 when the bottom part of the display
begins to blink.
OUT1 output during standby is set to 5%.
4
Press the key to confirm the setting.
5
Repeat steps 2-4 (excluding pressing and holding
the key) to set the range for OUT2.
6
Press the key to return to the operation PV/
SV display.
Standby Mode Settings
This is the procedure for specifying re-transmission output,
alarm output, and operation mode display in standby mode.
The following three settings are available:
• AO (Re-transmission Output)
• DO (Digital Output)
• PV/SV display (operation mode display)
These can be combined in the following four ways:
• Setting range
Re-transmission output: When turned off, the re-transmission
output becomes –3%.
Setting Standby Mode Output
This section explains how to set standby mode output by
using AO=ON, Digital=OFF, PV/SV=ON as an example.
SbMd AO
(Re-transmission
Output)
DO
(Digital Output)
PV/SV
display
0 ON OFF ON
1 ON ON ON
2 OFF OFF ON
3 OFF ON ON
4 ON OFF OFF
5 ON ON OFF
6 OFF OFF OFF
7 OFF ON OFF
1
Press and hold the key to display the setup
mode channel menu ("
ooo oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display SET ("
SSS
SEEEETTTT CCCChhhh 6666
").
Refer to
See p. 74 in this chapter for information on how to display
the operation menu.
2
Press and hold the key, then use the
keys to select "
SSS SbbbbMMMMdddd
".
3
Press the key, then use the keys to
select 0 when the bottom part of the display
begins to blink.
Standby mode output is set to "AO = ON, ALM = OFF,
PV/SV = ON".
4
Press the key to confirm the setting.
5
Press the key to return to the operation mode
PV/SV display.