FujiFilm PXG4, Operation Manuals

Page: 42 / 158

– 41 –
4
Chapter
Setting Output Limiter Types
When a limit is specified for the output value, you can
choose whether or not to apply the limit.
The output changes according to the limit, as follows.
Range can vary according to the following table.
Setting Output Limiters
Setting Output 1 (OUT1) Output 2 (OUT2)
lower limit upper limit lower limit upper limit
0 -3% 103% -3% 103%
1 limit 103% -3% 103%
2 -3% limit -3% 103%
3 limit limit -3% 103%
4 -3% 103% limit 103%
5 limit 103% limit 103%
6 -3% limit limit 103%
7 limit limit limit 103%
8 -3% 103% -3% limit
9 limit 103% -3% limit
10 -3% limit -3% limit
11 limit limit -3% limit
12 -3% 103% limit limit
13 limit 103% limit limit
14 -3% limit limit limit
15 limit limit limit limit
PHC
PLC
103%
output value
(before limiting)
PHC
PLC
limit
no limit
limit
no limit
–3%
output value
(after limiting)
1
Press and hold the key to display the setup
mode channel menu ("
ooo oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display Pid ("
PPP
Piiiidddd CCCChhhh 2222
").
Refer to
See p. 31 in this chapter for information on how to display
the channel menu.
2
Press and hold the key to display P ("
PPP P
"), then
use the keys to display PCUT ("
PPP PCCCCUUUUTTTT
").
Sets the output limiter types.
3
Press the key, then use the keys to set
the limit to 15.
All of the outputs are limited.
4
Press the key to confirm the setting.
5
Press the key to return to the operation mode
PV/SV display.