FujiFilm PXG4, Operation Manuals

Page: 39 / 158

– 38 –
4
Chapter
SV Lower Limits ,
SV Upper Limits
These settings specify the range to which SV can be set.
SV can be set to any value in the measurement range.
• Range: 0% to 100% FS (lower/upper limit)
The relationship between SV limits and the measurement
range is as follows:
Setting the SV Upper and Lower Limits
Caution
• Set the lower and upper SV limits only after setting the
following parameters in the setup menu.
PV Input Upper Limit ("
Pvb
") /Lower Limit ("
PvF
")
• SVs set before setting the SV limits (Local SV, Palette SV,
etc.) are affected by new SV limits.
• Make sure to set the value of SVh greater than SVL.
set value
PV input
upper limit
PV input
lower limit
SV upper limit
PV input range
SV lower limit
(upper limit > lower limit)
1
Press and hold the key to display the setup
mode channel menu ("
ooo oPPPPEEEE CCCChhhh 1111
"), then use the
keys to display Pid ("
PPP
Piiiidddd CCCChhhh 2222
").
Refer to
See p. 31 in this chapter for information on how to display
the channel menu.
2
Press and hold the key to display P ("
PPP P
"), then
use the keys to display SvL ("
SSS SvvvvLLLL
").
Specify the PV lower limit.
3
Press the key, then use the keys to set
the normal/reverse settings to "50" when the bottom
part of the display begins to blink.
The SV lower limit is set to 50°C.
4
Press the key to confirm the setting.
5
Repeat steps 2-4 (excluding pressing and holding
the key) to set the SV upper limit.
6
Press the key to return to the operation mode
PV/SV display.