FujiFilm PXG4, Operation Manuals

Page: 25 / 158

– 24 –
3
Chapter
Standby Switch
The following will switch you between operation mode and
standby mode.
The following items can be set beforehand in standby mode.
• Control output (-3.0% to 103.0%)
• Alarm output (ON/OFF)
• Re-transmission output (ON/OFF)
Switching Standby Mode
Refer to
See "Standby Mode Settings" (p. 85) for more information about
standby mode settings.
Point
• When "hold alarms" is on, the hold function activates
when standby settings switch from on to off.
• If the controller is switched to standby mode during
auto-tuning, auto-tuning will be cancelled. To complete
auto-tuning, turn standby mode off and restart auto-
tuning.
• When the controller switches to standby mode, the
delay on timer will be reset. It will begin again when
standby mode is turned off.
1
Press and hold the key to display the channel
menu of the setting mode, then use the
keys to display "
ooo oPPPPEEEE CCCChhhh 1111
".
Refer to
See p. 23 in this chapter for information on how to display
the channel menu.
2
Press and hold the key, then use the
keys to select STbY ("
SSS STTTTbbbbYYYY
").
Switch between Run and Standby.
3
Press the key, then use the keys to
display "on" when the lower part of the screen
begins to blink.
4
Press the key to confirm the setting.
Activate Standby Mode.
Control output, DO and other outputs are turned off.
5
Press the key to return to the PV/SV display
of the operation mode.
The SV display blinks when in
Standby Mode.
Switching Between Local
and Remote Operation
The following will switch you between local SV and
remote SV operation. In remote SV operation, SV is
controlled by an external SV input (RSV).
Switching Between Local and Remote Operation
1
Press and hold the key to display the channel
menu of the setting mode, then use the
keys to display "
ooo oPPPPEEEE CCCChhhh 1111
".
Refer to
See p. 23 in this chapter for information on how to display
the channel menu.
2
Press and hold the key, then use the
keys to display rEM ("
rrr rEEEEMMMM
").
Change between local and remote operation.
3
Press the key, then use the keys to
display "rEM" when the lower part of the screen
begins to blink.
4
Press the key to confirm the setting.
Activate remote operation.
5
Press the key to return to the PV/SV display
of the operation mode.
Caution
In remote operation, the keys on the front
panel cannot be used to change SV.
PV
PID
calculation
local
SV
remote SV
(DC0 〜 5/1 〜 5V)
control
output
Switch to remote SV
parameter rEM
"
RSV
" and the RSV value alternate