FujiFilm PXG4, Operation Manuals

Page: 20 / 158

– 19 –
2
Chapter
Steps for Setting Parameters
The following explains the steps from power-up to
operation.
Prepare Operation
1
Make a settings plan.
Decide how you want the controller to run and what
parameter values will be needed to make the
controller run to your specifications. At the very
minimum, you need to determine the following
settings:
• Input sensor type
• Normal or reverse operation
Refer to
"Normal/Reverse Settings" (p. 37)
• Control methods
Ex.) ON/OFF control, PID control
Refer to
"Proportional Bandwidth, Integration Time, Derivation Time"
(p. 31)
"ON/OFF Control Hysteresis" (p. 32)
• SV Value
Refer to
"SV Lower limit" (p. 38)
"SV Upper limit" (p. 38)
2
Turn the power on.
Confirm that the connections are correct, then turn on
the power.
Immediately after powering up, the controller will be in
operation mode. The PV and SV displays will
illuminate and display numbers. If nothing is
displayed, recheck the power source and connection.
3
Switch to Setup Mode. Set the parameters laid out
in your plan.
Refer to
Chapter 2 "Overview of Basic Operations and
Parameters: Basic Operations" (p. 12)
1
Confirm that controlled object will operate in
manual mode.
2
Test the controller with the auto-tuning or self-
tuning functions. Adjust the parameters
according to the results of the test.