6-18
897N203029A FDC NX600 Instruction Manual 2022.01
6 Maintenance
6.4 Replacing Recording Paper
When red lines appear along the sides of the recording paper, the printer is nearly out of paper, so
replace the recording paper roll with a new one.
NOTE
Use the recording paper specified for the FDC NX600.
2
1
Press the
concave
section.
1. Press the section indicated in the illus-
tration (
1
) to release the lock, and then
open the cover (
2
).
2. Remove the remaining recording paper.
3. Load the new recording paper.
NOTE
If the paper replacement was performed
during a measurement, the measure-
ment results might be printed out.
NOTE
Set the paper roll so the paper is pulled
from under the paper roll as shown below.
OK
Incorrect
NOTE
If the paper is loaded in reverse, no text
is printed on the thermal paper.
4. Pull the top end of the recording paper
out slightly, and then close the cover.
NOTE
When setting a new recording paper,
pull the edge of paper out to where the
tape for fixing edge is affixed. Failure
to observe this precaution may cause
printing malfunction.
NOTE
Close the cover securely until it clicks.
Otherwise, the paper feed may fail and
the test results will not be printed out.
6
