3-32
897N203029A FDC NX600 Instruction Manual 2022.01
3 Measurement
3.9.2 FUJI Sample Tubes
Use these tubes in the place of blood collection tubes when the sample volume is low.
WARNING:
When handling samples (blood or urine), always follow biohazard procedures (wear gloves, a lab
coat, and safety goggles) in accordance with the sample handling rules of your facility. If you acci-
dentally touch a sample, immediately rinse the contaminated area thoroughly under running water,
and then disinfect the area. Seek medical assistance if necessary.
検体上限
吸引限界
分離用
検体下限
1.5
0.5
0.3
0.1
1.0
0.5
0025
Upper
limit of
sample
Suction limit
Lower limit
of sample for
separation
Make sure that the sample volume is sufficient by
referring to the illustration to the left. The top sur-
face of the sample fluid must be within the shaded
section of the tubes in the illustration.
NOTE
If the sample in the tube is below the suc-
tion limit mark, the analyzer will indicate an
insufficient sample volume error.
NOTE
To aspire only the supernatant fluid (plasma)
of the centrifuged sample (and avoid aspi-
ration of red blood cells), at least 1.0 mL (for
a 1.5 mL tube) or 0.3 mL (for a 0.5 mL tube)
of a whole blood sample for separation is
necessary.
NOTE
Only 5 tests or fewer can be performed us-
ing a 0.3 mL whole blood sample with a
FUJI Sample Tube (0.5 mL).
Effective liquid surface range of a FUJI Sample Tube
1.5
0.5
0.3
0.1
0.5
1.0
検体上限
吸引限界
吸引限界
富士チューブ
サンプルカップ2ml
検体上限
注：検体は、50μl 以上必要です。
Upper limit of sample
Suction limit
NOTE: At least 50 µl of sample is needed.
3
