FujiFilm Frontier-S DX100, Service Manual

Page: 280 / 303

280
6.1General Overview
DX100 Service Manual
6.1 General Overview
This chapter provides information on how to maintain the printer in its
optimum operating condition.
Basically, servicing on the printer should be performed on-site. Be sure to
strictly observe the following precautions when servicing to avoid an
accident or injury causing the user trouble.
6.2 Inspection
Make sure to check the following parts and clean them if necessary.
6.3 Lubrication
This section describes necessary lubrication to maintain the functions and
performance of this printer. Make sure to properly lubricate the parts
specified in this section when replacing them.
LUBRICATION POINTS LIST
W A R N I N G
The Top Cover Open Sensor provided for detecting open/close status of the
Top Cover acts as a safety interlock switch.
Never disable the switch function unless the instructions are described in
this manual.
Table 6-1. List of Check Items
Check Item Frequency Description
Trimmed Waste
Paper Box
When replacing paper
Refer to User’s Manual.
Airflow vent Every three months Refer to User’s Manual.
C A U T I O N

Be sure to perform the lubrication by strictly adhering to the specified
application points, lubricants, and amount. Failing to do so may cause
a malfunction of the printer.

When lubricating the originally attached parts, wipe off the oil
adhering to the parts before performing the lubrication.
Table 6-2. Lubrication Points List
Corresponding Part
Name of
Lubricant*
Page
Roll
Me
cha
nis
m
Left roll lock lever/ right roll lock lever G-36 p281
Middle roll frame G-36 p282
Driven roller 1 mount plate G-36 p282
Driven roller 2 mount plate G-36 p283
Decurl roller mount plate G-36 p283
Inlet Roller G-36 p284
Feed Roller 1/ Feed Roller 2 G-36 p284
Grounding spring G-36 p285
Left roll spring plate/ right roll spring plate G-36 p285
Right decurl roller cam G-36 p286
Left decurl roller cam G-36 p286