FujiFilm Frontier-S DX100, Service Manual

Page: 173 / 303

173
4.5Disassembly and Assembly Procedure
DX100 Service Manual
4.5.6.10 Roll End Sensor
1. Remove the Trimmed Waste Paper Box. (P.98)
2. Remove the Roll Unit. (P.130)
3. Remove the eleven screws, and remove the two sheets.
A) Silver M3x6 P-tite screw : eleven pieces
4. Remove the two screws, and remove the grounding wire and Roll End Sensor.
B) Silver M3x6 S-tite screw : one piece
C) Silver M3x6 P-tite screw : one piece
Figure 4-132. Removing the sheet
5. Remove the grounding plate.
6. Disconnect the cable from the connector of the sensor.
7. Disengage the four hooks, and remove the sensor.
Figure 4-133. Removing the Roll End Sensor
A
Roll End Sensor
C
B
Sheet
Sheet
A
A
A
A
A
A
A
A
A
A
Grounding
Wire
Hook
Hook
Cable
Connector
Roll End Sensor
Grounding plate