FujiFilm Frontier-S DX100, Service Manual

Page: 17 / 303

17
1.2 Basic Specifications
DX100 Service Manual
1.2.4 General Specifications
Note : Notes on storage after unpacking

Store the printer in the state in which it was checked after operation. (Make sure the
Print Head is capped.)

If the print head is not capped while the power is off, carry out the startup check while
the ink cartridge is installed, then confirm that the print head is capped, and then carry
out the shutdown check and turn off the power.

Leave the ink cartridge and the maintenance cartridge attached to the main body of
the printer.

When storing more than six months, discharge the ink, then remove the ink cartridge
from the printer, and pack and transport the printer with the maintenance tank
installed.
Notes on transportation after unpacking

Remove the ink cartridge from the printer, and pack and transport the printer with a
new maintenance tank installed.

When transporting the printer by air, discharge the ink, then remove the ink cartridge
from the printer, and pack and transport the printer with a new maintenance tank
installed.

When transporting the printer, do not fall and tilt it.
Table 1-5. General Specifications
Item Specification
Temperature Operating : 10 - 35

C
Storage (before unpacked) : -20 - 60

C
(within 120 hours under 60

C, within
1 month under 40

C)
Storage (after unpacked) : -20 - 40

C
(within 1 month under 40

C)
Humidity Operating : 20 - 80 % (no condensation)
Storage (before unpacked) : 5 - 85 % (no condensation)
Storage (after unpacked)
: 5 - 85 % (no condensation)
Vibration Operating : 0.15 G, 10 - 55 Hz
Storage
: 0.5 G, 10 - 55 Hz
Impulsion Operating : Within 1 G, 1 ms
Storage
: Within 2 G, 2 ms
Humidity (%)
Temperature (

C)