FujiFilm Frontier-S DX100, Service Manual

Page: 109 / 303

109
4.5Disassembly and Assembly Procedure
DX100 Service Manual
4.5.3.3 Heater Board
1. Remove the Top Cover. (P.97)
2. Remove the Upper Cover. (P.100)
3. Remove the Rear Frame. (P.101)
4. Remove the Right Frame. (P.102)
5. Remove the Left Frame. (P.102)
6. Disconnect the cables from all connectors on the Heater Board. (Be sure to unlock the
connectors (CN1, CN2, CN3, CN11) before disconnecting the cable)
(4.6 Connector Position
"Heater Board (p206)" )
7. Remove the four screws that secure the heater board fixing plate.
A) Silver M3x6 Bind machine screw : four pieces
8. Release the cables from the four clamps and two wire saddles, then remove the heater
board unit.
Figure 4-36. Removing the heater board unit
C A U T I O N
Before working, wear an antistatic wrist band when handling the internal
circuit boards to prevent damage from static electricity.
A
A
Wire saddle Clamp Clamp Clamps
Heater Board
Unit
A
A
Heater board
fixing plate