FujiFilm FinePix30i, Service Manual

Page: 37 / 48

37
4.Adjustment
FinePix30i(U/E/EG) SERVICE MANUAL
U_model E/EG_model
Repair position Repair position ID Repair position Repair position ID
America 61(A) England 66(F)
Canada 62(B) Germany 67(G)
Hawaii 63(C) France 68(H)
Taiwan 64(D) Spain 69(I)
Others 65(E) Italy 6A(J)
Natherlands 6B(K)
Belgium 6C(L)
Sweden 6D(M)
Switerland 6E(N)
Norway 6F(O)
Finland 70(P)
Singapore 71(Q)
Others 72(R)
4-4-8.End setting
(1) Press the [F12] key on the PC keyboard to select [F12] End setting from the Adjustment item menu.
Selection of such items as Destination and Repair position, and writing of USB_ID, are also included in End setting,
and the program is then terminated.
Press [F12] on the Adjustment item menu to display the Destination Select screen. Select the destination.
* Enter the number with the 10-keys on the PC keyboard (Fig.36).
(2) When Destination has been selected, select the Repair position when asked. (Fig.37).
J
Fig.36
(3) When the Repair position has been selected, write the data necessary for changing the camera from the JIG mode
to the NORMAL mode.
The camera does not operate in the JIG mode after power is switched OFF -> ON.
When all adjustment has been completed, remove the DC power supply connector to complete adjustment (Fig.38).
Terminate the program by selecting [Operation] -> [End] from the menu bar.
Fig.37
Fig.38
(note)
Since a USB device must be unique among individual units and be the only such device in the world, USB standards
mandate that a unique ID be given to each unit. Accordingly, if the main PWB assembly is replaced, the ID of the repair center
must be entered to grant a new unique device ID. The location of the repair centers are shown in the table below. (Writing
this data to the EEPROM is performed by the PC adjustment software. Follow its instructions.)
**Indicates ASCII code ( ) indicates decimal
notation
<< Repair position ID NO. >>