FujiFilm FinePix S5100, Service Manual

Page: 51 / 96

51
4. Adjustment
FinePix S5100/S5500 Service Manual
4-8. [R] : Flash Memory Reset
<Note>
Only reset the flash memory when the MAIN PWB ASSY has been replaced.
When the MAIN PWB ASSY has been replaced, always reset the flash memory before making any other adjustments.
If the flash memory is reset when the MAIN PWB ASSY has not been replaced, all the adjusted data reverts to the default
settings.
In this event, adjust all the settings.
(Excludes firmware downloading.)
After the MAIN PWB ASSY has been replaced, proceeding with other adjustments without first resetting the flash memory
will prevent the successful completion of the adjustments.
(In some cases the camera may be completely disabled.)
If this occurs, set the camera to jig mode again and then reset the flash memory.
<Step 1>
In the adjustment item selection screen, select [R]: Reset flash memory.
-->The flash memory reset confirmation screen appears.
-->The [Reconfirm flash memory reset] screen then appears.
Flash memory reset (EVR)
< Attention >
When the MAIN PWB ASSY has been replaced, always reset
the flash memory before making any other adjustments.
Only reset the flash memory when the MAIN PWB ASSY
has been replaced. If the flash memory is reset when the
MAIN PWB ASSY has not been replaced, all the adjusted data
reverts to the default settings. In this event, adjust all the
settings. (Excludes firmware downloading.)
Enter [RESET] from the PC keyboard.
<Fig. 4-8-1>