FinePix S3Pro TROUBLESHOOTING GUIDE
7
3. Image and trace
3-1. Dust specks appear in photographed images
Fault details:
Dust specks appear in photographed images.
Analysis results:
Dust on the LPF.
Repair details:
Cleaned the LPF
3-2. Sync. terminal dislodged
Fault details:
When the sync. terminal cap was removed, the terminal itself broke off.
Analysis results:
Presumed to be caused by looseness due to incomplete fastening and adhesion when the
sync. terminal was attached.
Repair details:
Replace the Sync. terminal
3-3. The camera does not automatically switch to vertical position when auto rotate function
is set to ON
Fault details:
The camera does not automatically switch to vertical position when auto rotate function is
set to ON.
Analysis results:
Defect in MAIN PWB ASSY IC120 (vertical position detection sensor).
Repair details:
See Bulletin GS-2005-025
3-4. The camera does not automatically switch to vertical position when auto rotate
function is set to ON
Fault details:
The camera does not automatically switch to vertical position when auto rotate function
is set to ON.
Analysis results:
Defect in the vertical position detection sensor mounted on a modified board.
Repair details:
Replaced the vertical position detection sensor (IC120).
