FujiFilm DR-ID 1300, Service Manual

Page: 84 / 628

DR-ID 1300 / DR-ID 1300PU Service Manual
MT-7
MT-7
018-234-06E
2. Error Code Table
Error
Code
Error Name Occurrence Condition Probable Cause and Remedy
10150
Memory map reconfiguration
error
A retry of memory map reconfiguration is made, but an error is detected,
resulting in system shutdown.
10212 FPD high temperature error
[During bootup/routine processing]
A high temperature (Approx. 60°C or higher) of the FPD is detected,
resulting in system shutdown.
<Reference>
- You can know the No. of the FPD of interest and the temperature when
the error is detected on the error log.
- This temperature is an estimate since it fluctuates depending on the SE
type and the external temperatures.
- Check the temperature and humidity of the examination
room.
- Check the FPD.
10213 FPD low temperature error
[During bootup/routine processing]
A low temperature (Approx. -10°C or lower) of the FPD is detected,
resulting in system shutdown.
<Reference>
- You can know the No. of the FPD of interest and the temperature when
the error is detected on the error log.
- This temperature is an estimate since it fluctuates depending on the SE
type and the external temperatures.
- Check the temperature and humidity of the examination
room.
- Check the FPD.
10214 IP address multiple connection
error
[During bootup/routine processing]
The FPD with the same IP address is connected, and the system shuts
down.
- Check the IP address setting.
10600 Correction data load error
[During bootup]
An attempt is made to read the correction data from the SSD and load
onto the CPU board memory and the SODIMM mounted on the SPC
board, but read from the SSD fails. After two retries are made, a retrial
count is over, resulting in system shutdown.
<Reference>
You can know the file name where a failure in loading occurs on the error
log.
- Check the SSD.
10601 System file load error
[During bootup]
An attempt is made to read the system file (except the correction data)
from the SSD and load onto the CPU board memory and the SODIMM
mounted on the SPC board, but read from the SSD fails.
<Reference>
You can know the file name where a failure in loading occurs on the error
log.
- Check the SSD.