FujiFilm DR-ID 1300, Service Manual

Page: 393 / 628

IN1-12
IN1-12
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-05E
6.4 Connecting the Cables
(1) Route the SE cable (For stand and for bed) from the lower opening on
the MP rear cover, and connect the cable connector and the protective
ground wire.
#1 Route: SE cable and protective ground wire
#2 Connect: Cable connector (For stand: MPL5 and MPL7, for bed: MPL6 and
MPL8)
#3 Tighten: N3x6, SW3, W3
#4 Clamp: Clamp
#5 Tighten: protective ground wire
1300_700007E.ai
#1
#2(for stand)
#2(for bed)
#4
#3
#5
u
NOTE
u
- Connect the stand SE cable to the MPL5 and MPL7 cable connectors, and
connect the bed SE cable to the MPL6 and MPL8 cable connectors.
- Firmly secure the #4 clamps. If they are not secured, there might be noise
effects.
(2) Tighten the SE cable (MP-side) with the two cable ties that are passed
through the clamp, and attach the ferrite core (FC1).
#1 Tighten: Cable tie (Panduit PLT1.5I: lateral direction, inside)
#2 Tighten: Cable tie (Panduit PLT1.5I: vertical direction, outside)
1200_700059E.ai
SE cable
MP
#1
#3
#2
INSTRUCTION
When tightening the cable tie, adjust the length of the cable tie as in the figure below.
When measuring the length of the cable tie, set the steel rule up against the
cable bundle tie and measure the length to the tip.
1200_700175E.ai
Cable tie (inside)
105 mm or more
Cable tie (outside)
97 mm or more