FujiFilm DR-ID 1300, Service Manual, Page: 242 / 628

MU1-77
MU1-77
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-06E
1.9.9 Replace Long Panel RMV Board
When the RMV board is replaced, if [SET] is clicked after the SE serial ID is input,
then the communications setting file installation or Extra Sleep mode can be gone to.
u
NOTE
u
The first letter of the serial ID must be entered as a capital letter.
REFERENCE
The serial ID of an SE is mentioned on the surface of the machine-specific data CD-
ROM.

Install Communication File
Install the communication setting file to the RMV board of the target panel unit.
1300_410007E.ai
(1)
(3)
(2)
(1) Click “UTILITY” - “Replace Long Panel RMV Board”.
The Replace Long Panel RMV Board window opens.
(2) Select the target SE ( Panel units ) from the drop-down list box.
(3) Click [START] in the “Install Communication File”
The communication setting file will be installed on the RMV board.

Execute Extra Sleep
After replacing the RMV board, to write the serial ID on it, you need to stop the
communication with the RMV boards installed in the other panel units. Click [START]
in the “Execute Extra Sleep” to stop the communication with the selected panel unit.
1300_410008E.ai
(1)
(3)
(2)
(1) Click “UTILITY” - “Replace Long Panel RMV Board”.
The Replace Long Panel RMV Board window opens.
(2) Select the target SE ( Panel units ) from the drop-down list box.
(3) Click [START] in the “Execute Extra Sleep”
Stop the communication with the selected panel unit.
u
NOTE
u
After the Extra Sleep is executed, the serial ID forced writing will be performed in the
replaced RMV board.
{MU1:1.9.8._Force Serial ID Writing}