FujiFilm DR-ID 1300, Service Manual, Page: 190 / 628

MU1-25
MU1-25
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-06E
1.4 CALIBRATION
1.4.1 SE Calibration
u
NOTE
u
For the DR-ID 1300, perform the following calibration.
{MU1:1.4.2._Long Panel Calibration}
Used to make the following calibration on the SE.
Refer to the Installation manual for the detailed procedures.
{IN1:11._Image Calibration}
{IN2:11._Image Calibration}
- Offset Calibration
- Gain Calibration
- Defect Calibration
- Lag Calibration
u
INSTRUCTION
u
Check to make sure that background calibration (which takes place automatically
when the MC is started) is completed before carrying out the following calibration.
The image correction data cannot be correctly performed if the calibration takes place
while the background calibration is in progress.
- Offset Calibration
- Gain Calibration
- Defect Calibration
- Lag Calibration
You can check whether background calibration is completed on the status lamp
“READY” of the SE
- While background calibration is in progress:
“READY” is flashing.
- While background calibration is not carried out:
“READY” is unlit.
u
NOTE
u
When performing the calibration with the FIPS MODE set to “ON” in the
CONFIG
SETTING
, a warning message is displayed to indicate that the data transfer rate is
slow. Set the FIPS MODE to “OFF” or perform the calibration after wire-line connecting
the SE.
1200_400067E.ai
(1)
(2)
(3)
(1) Click “CALIBRATION” - “SE Calibration”.
The SE Calibration window opens.
(2) Select the target SE from the drop-down list box.
(3) Implement each calibration.