FujiFilm DR-ID 1300, Service Manual

Page: 183 / 628

MU1-18
MU1-18
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-06E
1.3.2 RU Image Flag
1200_400064E.ai
(1)
(2)
(1) Click “CONFIG SETTING” - “RU Image Flag”.
The RU Image Flag window opens.
(2) To change the setting values, input the “Updated Value”, and click [SET]
at the bottom of the window.
The data is written into the HDD.
u
NOTE
u
Do not turn OFF the power of the MC during write into the HDD. Otherwise, the
HDD data gets damaged, and the MC cannot boot up.
(3) Left-click the MC Manager from the task tray and execute “EXIT”.
Check that the MC Manager icon has disappeared from the task tray,
and then start the MC Manager from “Start menu” → “Start-up”.
REFERENCE
The settings become effective after restart of the MC.

Setting Items

GOS SHARPNESS FILTER
Select the sharpness of the GOS panel (1201SE, 1202SE).
Select HIGH when a highly sharp image is to be obtained, making use of the features
of DR.
Select NORMAL when an image with normal sharpness close to the FCR is to be
obtained.
<Options>
- HIGH [default]: Highly sharp
- NORMAL: Normally sharp
u
NOTE
u
As this setting causes a large change of the image quality, select according to the
desire of the user.
REFERENCE
This setting does not influence the image quality of the CsI panel (1211SE / 1212SE /
1213SE / 1214SE).

IMAGE READING MODE
u
NOTE
u
For the DR-ID 1300 series SE, this setting is disabled.
Selects the image compensation processing mode.
Normally use the default setting. If the noise is generated via image evaluations
whereas physical phantoms such as mesh, etc. were used, change to the Standard
Mode.
<Options>
- Standard Mode
- High-Speed Mode [default]
u
NOTE
u
When this setting has been changed, perform the full calibration after restarting the
MC in the following procedure. If not, the image compensation processing mode is not
switched correctly.
1. Change the setting.
2. Restart the MC.
3. Perform the full calibration.