FujiFilm DR-ID 1300, Service Manual

Page: 100 / 628

MT-23
MT-23
DR-ID 1300 / DR-ID 1300PU Service Manual
018-234-06E
5. BACKUP FILE
5.1 CALIB LOG
How to read the CALIB LOG file is as follows.
[2014/10/21 15:29:58] 3AA988 @<P1, L121402, center> <C4> <M0>xxxxx
Date and time TICK after
the MC
application
starts up
（
10ms units
）
SE
reg No.
(1-100
）
SE
serial
ID
SE
position
(DR-ID
1305SE
only)
Calibration
type
Read
mode
Results
- Calibration type
C1: Offset calibration C2 : Gain calibration
C3
:
Lag calibration C4
:
Automatic offset update
C5
:
Defect calibration C7
:
Marker calibration
- Read mode
M0: mode 0 M1: mode 1 M2: mode 2
- Results
For offset calibration:
- Results (success, abort, fail)
- Response results from the SE (3 words)
For gain calibration:
- Results (success: "0", fail: other than "0"
）
For defect calibration:
- Results (success: "0", fail: other than "0" ）
- Defect detection results
- Histogram of the defect size (DefectSizeHistogram)
- Histogram of the defect cluster (DefectClusterHistogram)
- Horizontal line defect / vertical line defect (LineH/LineV)
- Number of the defect pixels (NumberOfDefectPixel)
For lag calibration:
- Results (success: "0", fail: other than "0"
）
- ROI number (NumOfROI_x/NumOfROI_y)
- ROI coordinates of the exposure part per ROI numbers (IROI/x1/y1/x2/y2)
- ROI coordinates of the Pb part per ROI numbers (PbROI/x1/y1/x2/y2)
- Acquisition timing for each frame, average QL of ROI for each exposure part,
and average QL of ROI for each Pb part (Frame/Time/QLave_X/QLave_Pb)
- Judgment results for lag correction ON/OFF (JudgementCorrect)
- Decay constant per ROI numbers (IROI/A(iROI))
For marker calibration:
- Results (success: "0", fail: other than "0"
）
- Calibration mode (Factory mode: "factory", Maintenance mode: "maintenance")
- Border edge factor for quadruple exposures (BorderEdge)
- Marker calibration results (MarkerCalibResult)