FujiFilm CR-IR341, Service Manual

Page: 863 / 1472

CR-IR341 Service Manual MU - 72 009-051-05
11.20.99 FM2638
2 3 4 5 6 7 9 10 1 8 C
ONTENTS
MU - 72
8. 3. TEST MODE: Operation Setup
It is used when the IP conveyance operation is to be checked and for other purposes. After
checking the conveyance operation, “1: ROUTINE” should be selected to return the machine
back to the state suitable for routine processing.
8.1 1. ROUTINE: Setting Operation Mode of Routine
Processing
The settings made in “2. AUTO MODE” are canceled and the machine is rendered into a
state appropriate for routine processing.
Be sure to perform this setup before performing routine processing after “2. AUTO MODE” is
selected.
8.2 2. AUTO MODE: Setting Operation Mode of Conveyance
Test
With the settings of the operation mode and the number of conveyance, when the IP cas-
sette is put into the cassette set unit in the routine processing mode, IPs are automatically
conveyed a set number of times.
Three types of operation modes are available as follows.
■
1. READING & ERASURE
Reading operation is performed as usual to output an image, while the image on the IP is
erased.
This mode is used to test the image reading function, along with the IP conveyance function.
■
2. PRIMARY ERASURE
The image is read to detect the dosage on the IP, and IP erasure is performed according to
the dosage.
The image so read is not outputted because the objective of this mode is to detect the
amount of erasure for the IP.
This mode is used when it is not necessary to test the image reading function but the image
on the IP used for conveyance is to be erased.
■
3. SECONDARY ERASURE
The IP is conveyed through the reading unit without reading the image, and its erasure is
performed quickly regardless of the dosage on the IP.
This mode is used to merely check the mechanism of the IP conveyance function.