FujiFilm CR-IR341, Service Manual

Page: 757 / 1472

CR-IR341 Service Manual MC - 262
009-051-04
05.31.99 FM2460
12 13 14 15 11 16 C
ONTENTS
MC - 262
14. Cleaning IP
After cleaning the IP, use the IP cleaned to perform IP conveyance checks.
■
Cleaning Procedures
(1) Take out the IP from the cassette.
(2) Wipe the fluorescent surface of the IP with gauze.
After moving the gauze in a straight fashion, move the gauze in small circles, as
illustrated below, to wipe the IP clean.
If soils persist after cleaning with dry gauze, proceed to step (3). If soils are cleaned
off, proceed to step (4).
(3) Wipe the IP with ethanol-moistened gauze.
After wiping the IP with ethanol-moistened gauze, immediately wipe it with dry gauze
to remove traces of alcohol left on the fluorescent surface of the IP, and wait until it is
completely dry.
(4) Put the IP into the cassette with its fluorescent surface down.
■
IP Conveyance Check
(1) Power ON the machine.
(2) Touch the U-Utility button.
➮
The screen switches to the U-Utility mode.
(3) Touch the upper left corner and upper right corner of the operation panel.
➮
M-Utility is activated.
(4) Select “3. TEST MODE”, “2. AUTO MODE”, and “2. PRIMARY ERASURE” in se-
quence.
➮
A message prompting for the number of conveyances appears on screen.
(5) Enter the number of IPs cleaned as a value.
(6) Repeatedly select “0. QUIT” to exit M-Utility.
(7) Touch the “RETURN” button.
(8) Insert the cassette that contains the cleaned IPs into each of the shelves.
➮
IP conveyance starts.
(9) Make sure that there is no offensive noise or odor from the machine during IP
conveyance.
(10) After the IP conveyance, take out the cassette and verify that the IPs are free of
scratch or other damage.
IP
FR1H1314.EPS
009-051-06
04.20.2001 FM3006