FujiFilm CR-IR341, Service Manual

Page: 1277 / 1472

CR-IR341
Service Manual
IN - 80 009-051-07
08.30.2001 FM3115
2 3 4 5 6 7 1 8 A1 A2
C
ONTENTS
IN - 80
6.2.1 Removal of Covers
Remove the covers in the following order.
(1) Lower front cover
While slightly pulling the top of the cover toward yourself, lift it up and out.
(2) Upper right-hand side cover (truss M4x6, x4)
Pull up the entire cover toward yourself and out.
(3) Lower right hand side cover (truss M4x6, x9)
While slightly pulling the top of the cover toward yourself, pull it up and out.
(4) Upper rear cover (truss M4x12, x4)
(5) Lower rear cover (truss M4x12, x8)
While slightly pulling the top of the cover toward yourself, pull it up and out.
(6) Upper left-hand side cover (truss M4x12, x4)
(7) Lower left-hand side cover ( truss M4x6, x3; truss M4x12, x6)
While slightly pulling the top of the cover toward yourself, pull it up and out, exercising
care to prevent the cover of the switch portion from hitting the power supply unit.
Remove the single tape that retains the filter cover. Because the three screws on the
front side of the machine are truss M4x6, while the six screws on the rear side of the
machine are truss M4x12, use care not to confuse these screws during installation.
(8) Upper front cover (BR M4x8, x2)
While slightly pulling the top of the cover toward yourself, pull it up and out. Also
remove the single tape that retains the FD cover in place.
(9) Stack table (truss M4x6, x2)
Using a 2-mm Allen wrench or so forth, first remove the screw covers and then the
screws.