FujiFilm ClearView CS, Service Manual

Page: 1281 / 1404

CR-IR 363
Service Manual
PM-80
PM-80
011-202-08E
09.30.2009 FM5540
13. Erasure Conveyor Unit
13.1 Removing the Lamp Assembly
#20001 or later: {PM:14.1} {PM:13.2}
#50001 or later: {PM:14.4} {PM:13.2} {PM:14.5}
CAUTION
Do not touch the surface (filter face)of the lamp assembly immediately after the
operation is stopped. Since it remains at high temperatures, you may suffer
burns.
u
NOTE
u
The shapes of lamp assembly differ between #20001 or later and #50001 or later;
however, removal procedures are same.
1.
Remove the lamp assembly.
u
NOTES
u
- When handling the lamp assembly, wear gloves so that the filter located on the
bottom face of the lamp assembly is not soiled.
- Do not grasp the filter face when holding the lamp assembly. Otherwise, the
shock absorbing member might be peeled off.
- Place the lamp assembly with the filter face up. If the lamp is placed with the
filter face down,the filter may be damaged.
u
INSTRUCTION
u
When handling the lamp assembly, take hold of the portions illustrated below.