124
9 Changing the Machine Settings
[TEL/FAX Mode]
If there is an incoming transmission from the sender, fax receipt will begin after the external
telephone rings for the interval specified in [TEL/FAX Mode] of [Auto Answer Setup]. When the caller
is using a telephone, a ring tone will sound from the speaker built into the machine.
[Ans/FAX Mode]
This configuration assumes use of a telephone answering machine. When a signal arrives from the
caller, it is detected as either a fax transmission or voice call. When the caller is sending a fax, the fax
will be received automatically, and when a voice call is being made, the caller's message will be
recorded by the answering machine. If the power supply to the answering machine is turned off, the
machine's receiving mode will automatically switch to [FAX Mode] after the ring tone sounds for the
interval specified beforehand.
[DRPD Mode]
Before using the Distinctive Ring Pattern Detection (DRPD) option, a distinctive ring service must be
installed on your telephone line by the telephone company. After the telephone company has
provided a separate number for faxing with a distinctive ring pattern, configure the fax setup to
monitor for that specific ring pattern.
[Ring Tone Volume]
Specify ring tone volume. This setting is enabled when [Receive Mode] is [TEL/FAX Mode], and the
ring tone sounds from the machine's built-in speakers for a phone call from the sender.
[Auto Answer Setup]
Specify the settings for automatic fax reception.
[FAX Mode]
Set the interval at which the machine goes into the fax receive mode after receiving an incoming call.
[TEL/FAX Mode]
Set the interval at which the machine goes into the fax receive mode after the external
telephonereceives an incoming call.
[Ans/FAX Mode]
Set the interval at which the machine goes into the fax receive mode after the external answering
machine receives an incoming call.
[Junk Fax Filter]
Specify whether to reject faxes from fax numbers not registered in the address book of the machine.
[Forward Settings]
Specify whether to forward incoming faxes to specified destinations.
[Off]
Print incoming faxes from the machine.
[Forward]
Forwards incoming faxes to specified destinations.
[Forwarding Number]
Enter a fax number for the destination to which incoming faxes are forwarded.
[Print and Forward]
Prints incoming faxes from the machine, and forward them to a specified fax number.
[Forwarding Number]
Enter a fax number for the destination to which incoming faxes are forwarded.
