Fuji Xerox DocuPrint CM225FW, User Manual, Page: 280 / 344

280 Troubleshooting
 The Output Is Too Light
NOTE:
• If the problem continues even though you have taken suggested actions described above, contact the Fuji Xerox local
representative office or an authorized dealer.
Problem Action
The output is too light. The toner cartridges may be low or need to be replaced. Confirm the amount of
toner in each toner cartridge.
1 Check the toner level in the Status tab in the Printer Status window of the
SimpleMonitor.
2 Replace the toner cartridges as necessary.
Verify that the print media is dry and the correct print media is used.
If not, use the print media recommended for the printer.
See also:
• "Usable Print Media" on page 95
Try changing the paper type setting in the print driver. The following procedure
uses the Microsoft
®
Windows
®
print driver as an example.
1 On the Paper/Output tab in Printing Preferences of the print driver, change
the Paper Type setting.
2 Load dry (not damp) and correct size print media, and then click Print Test
Page in the Properties window of the print driver.
Disable the toner saving feature in the print driver.
See also:
• "Conserving Supplies" on page 333