Fuji Xerox DocuPrint CM205 b, User Manual

Page: 337 / 471

Using the Operator Panel Menus and Keypad 336
• Power Saving Timer
Purpose:
To specify the time for transition to the Power Saver mode.
Values:
Enter 5 in
Low Power Timer
to put the printer in the Low Power mode five minutes after it finishes a
job. This uses less energy, but requires more warm-up time for the printer. Enter 5 if your printer
shares an electrical circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. In most circumstances, this keeps the printer
ready to operate with minimum warm-up time. Select a value between 5 and 30 minutes for the Low
Power mode if you want a balance between energy consumption and a shorter warm-up period.
The printer automatically returns to the standby mode from the Power Saver mode when it receives
data from the computer. In the Low Power mode, you can also return the printer to the standby mode
by pressing any button on the operator panel. In the Sleep mode, you can return the printer to the
standby mode by pressing the
( Energy Saver ) button.
• Auto Reset
Purpose:
To automatically reset the settings for copying, scanning, or faxing to the defaults and return to the
standby mode after you do not specify any settings for the specified time. (The fax feature is available
only on the DocuPrint CM205 f/CM205 fw.)
Values:
• Fault Time-Out
Purpose:
To specify the time taken by the printer before it cancels jobs that stop abnormally. The job is
cancelled if it times out.
Values:
Low Power Timer 5min * Specifies the time taken by the printer before it enters the Low
Power mode after it finishes a job.
5–30min
Sleep Timer 6min * Specifies the time taken by the printer before it enters the
Sleep mode after it goes into the Low Power mode.
1–6min
45sec*
1min
2min
3min
4min
Off Disables the fault time-out.
On 60sec* Specifies the time taken by the printer before it cancels for jobs
that stop abnormally.
3–300sec