Fuji Xerox Document Centre C250, User Manual

Page: 307 / 556

Fax Mode Settings
305
Setups
11
Redial Interval
Set the redialing interval from 1 to 15 minutes, in 1 minute increments.
Note • In order to use this feature, it must first be enabled by a customer engineer.
Please note that this feature is not available in some countries.
Transmission Interval
Set a value for the interval between the end of one transmission and the beginning of
the next, from 3 to 255 seconds, in 1 second increments.
A longer transmission interval increases the total time to send a broadcast
transmission, for example, but allows calls to be received during the standby time.
Batch Send
A batch send means that when multiple transmissions have been stored for the same
address, the documents are sent in a single transmission to the address, and this sets
whether or not to do this. When set, the communications cost can be reduced.
Note that a batch send is not possible for manual transmissions, broadcast, relay
broadcast, mailbox transmissions, and transmissions with a specified time before the
specified time. When using a redial, resend, or delayed start send transmission job, or
a Copylyzer or Doculyzer, to send to the same address from different users, then a
batch send is not possible.
Manual Send/Receive Default
When using on-hook, set whether the initial state of the touch screen is manual
receiving or manual transmission.
Auto Switch Attempts
Set the number of times the phone ring should sound for an incoming call before
starting fax communications. Set a value from 0 to 9 rings.
If the other party is a telephone, within the set number of rings you can use an external
telephone to answer the call, and if it is a fax, switch manually to receiving.
Note • In order to use this feature, it must first be enabled by a customer engineer.
Please note that this feature is not available in some countries.
Fax Receiving Mode
You can set the default value for [Fax Receiving Mode] in the [Machine Status] screen
displayed by pressing the <Machine Status> button. Select whether to receive a fax
transmission automatically or manually.
Border Limit
When the length of a received document is more than the paper size, set the length to
make a page break. Set a value from 0 to 127 mm, in 1 mm increments.
This setting can conveniently be used together with the auto reduce on receipt feature.
Auto Reduce on Receipt
When the length of a received document exceeds the paper length but is within the
page break threshold value, select whether to automatically reduce the image to fit the
page.
This setting can conveniently be used together with the page break threshold value. If
you select [No], the part of the image beyond the paper length is discarded.