Fuji Xerox Document Centre C250, User Manual

Page: 300 / 556

11 Setups
298
Setu
ps
11
Border Erase - Left & Right
Set the default value for the amount of border erased from the original in the left and
right directions in [Border Erase] in the [Scan Options] screen. Set a value from 0 to 50
mm, in 1 mm increments.
Center Erase
Set the default value for the center erase amount of the original in [Border Erase] in the
[Scan Options] screen. Set a value from 0 to 50 mm, in 1 mm increments.
Image Compression
Set the default value for [Image Compression] in the [Output Format] screen.
Scan-to-FTP/SMB Defaults
You can select the default protocol used for transfer from FTP, SMB, and SMB (UNC
format).
1
Select [Scan-to-FTP/SMB
Defaults].
2
Select [Change Settings].
3
Select the setting value.
4
Select [Save].
Scan Size Defaults
Set the original size shown in [Scan Size] in the [Scan Options] screen.
An original size is assigned to each of the eleven buttons other than [Auto Detect].
When frequently scanning nonstandard size originals, by presetting a nonstandard
size, scan it is not necessary to enter the original size each time a scan is made.
Note that to set the nonstandard size, with [Variable Size] the width is set from 15 to
432 mm, and the height from 15 to 297 mm, in 1 mm increments.
1
Select [Scan Size Defaults].
2
Select the item to be set or
changed, and select [Change
Settings].
Note • Select [ ] to display the
previous screen and select
[
] to display the next screen.
3
Select the setting value.
4
Select [Save].