Fuji Xerox Document Centre C250, User Manual

Page: 293 / 556

Print Mode Settings
291
Setups
11
4
Select [Save].
Note • When a port is set to [Disabled], the corresponding items do not appear.
• Depending on the amount of data sent from the client, increasing the memory capacity may
not change the time taken to release the client.
PostScript Memory
Specify the memory capacity used for PostScript.
Set a value from 8.00 to 96.00 MB, in 0.25 MB increments.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• The maximum value that can be set varies according to the available memory capacity.
HP-GL/2 Auto Layout Memory
Specify the memory capacity used for HP-GL/2.
Set a value from 64 to 5120 KB, in 32 KB increments.
Note • This feature appears when the emulation kit or PostScript3 kit is installed.
• The maximum value that can be set varies according to the available memory capacity.
Receiving Buffer - Parallel
Set the parallel receiving buffer.
Set a value from 64 to 1024 KB, in 32 KB increments.
Receiving Buffer - USB
Set the receiving buffer for USB.
Set a value from 64 to 1024 KB, in 32 KB increments.
Note • This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
Receiving Buffer - LPD Spool
„
Off
Do not use spooling. While LPD print processing is being carried out for one client, data
cannot be received over the same interface from another client. Set a value for the
dedicated LPD receiving buffer memory capacity from 1024 to 2048 KB, in 32 KB
increments.
„
Memory
Carry out spooling. The receiving buffer for spooling uses memory. When this
candidate value is selected, set the memory capacity of the receiving buffer for
spooling, from 0.50 MB to 32.00 MB, in 0.25 MB increments.
Note that print data exceeding the set memory capacity is not accepted. In such cases,
select [Hard Disk], or [Off].
„
Hard Disk
Carry out spooling. The receiving buffer for spooling uses the hard disk.
Receiving Buffer - NetWare
Set the NetWare receiving buffer.
Set a value from 64 to 1024 KB, in 32 KB increments.