Fuji Xerox DocuCentreS2320, User Manual

Page: 45 / 257

Using CentreWare Internet Services
45
Env
ironm
e
nt
Sett
in
gs
2

Time to Low Power Mode
You can set the time elapse from the last operation until the machine enters Low Power
mode. You can set a value between 1 and 60 minutes. (Default: 1)

Time to Sleep Mode
You can set the time elapse from Low Power mode until the machine enters Sleep mode. You
can set a value between 1 and 239 minutes. (Default: 1)

[Apply] button
You can apply changes by pressing this button.
Port Settings (Connectivity)

Port
You can activate or deactivate communication ports. You can select from SNMP, SMB, LPD,
Port9100, Send E-mail, and Network TWAIN. Activate each port by checking its checkbox.

[Apply] button
You can apply changes by pressing this button.
Note • Reboot the machine to enable new settings.
Ethernet (Connectivity > Physical Connections)

Rated Speed
You can set the Ethernet port speed. You can select from Auto, 10 Mbps Half-Duplex, 10
Mbps Full-Duplex, 100 Mbps Half-Duplex, or 100 Mbps Full-Duplex. (Default: Auto)

MAC Address
The machine's MAC address is displayed.

[Apply] button
You can apply changes by pressing this button.
Note • Reboot the machine to enable new settings.
TCP/IP (Connectivity > Protocols)

IP Mode
You can set the IP operation mode. You can select from Dual Stack, IPv4, or IPv6. The Dual
Stack setting lets you use both IPv4 and IPv6 addresses. (Default: IPv4)

General
 Protocol
[Enabled] is displayed.
 Physical Connection
[Ethernet] is displayed.

Host Name
You can set the host name. You can enter between 1 and 32 single-byte alphanumeric
characters or hyphens. (Default: last 16-digit of the MAC address).
Note • Hyphens (-) cannot be used as the first or last character in the string.
 IPv4