Fuji Xerox DocuCentre S2220, User Manual

Page: 49 / 311

Using CentreWare Internet Services
49
Env
ironm
ent
Sett
in
gs
2
Port Settings (Connectivity)
„
Port
You can activate or deactivate communication ports. You can select from SNMP, LPD, and
Port9100. Activate each port by checking its checkbox.
„
Apply button
You can apply changes by pressing this button.
Note •
Reboot the machine to enable new settings.
Ethernet (Connectivity > Physical Connections)
„
Rated Speed
You can set the Ethernet port speed. You can select from Auto, 10 Mbps Half-Duplex, 10
Mbps Full-Duplex, 100 Mbps Half-Duplex, or 100 Mbps Full-Duplex. (Default: Auto)
„
MAC Address
The machine's MAC address is displayed.
„
Apply button
You can apply changes by pressing this button.
Note • Reboot the machine to enable new settings.
TCP/IP (Connectivity > Protocols)
„
IP Mode
You can set the IP operation mode. You can select from Dual Stack, IPv4, or IPv6. The Dual
Stack setting lets you use both IPv4 and IPv6 addresses. (Default: IPv4)
„
General
z
Protocol
[Enabled] is displayed.
z Physical Connection
[Ethernet] is displayed.
z Host Name
You can set the host name. You can enter up to 32 single-byte alphanumeric characters
or hyphens. (Default: last 16-digit of the MAC address).
Note • Hyphens (-) cannot be used as the first or last character in the string.
z IPv4
- IP Address Resolution:
You can set the method used to acquire the IP Address, Subnet Mask, and Gateway
Address. You can select from STATIC, DHCP, BOOTP, RARP, or DHCP/Autonet for the
address acquisition method. (Default: DHCP/Autonet)
- IP Address:
You can enter the IP address when [STATIC] is selected for [IP Address Resolution].
- Subnet Mask:
You can enter the subnet mask when [STATIC] is selected for [IP Address Resolution].
- Gateway Address:
You can enter the gateway address when [STATIC] is selected for
[IP Address Resolution].