Fuji Xerox DocuCentre-IV C2263, User Manual

Page: 144 / 443

3 Copy
144
Co
py
3
„
Staple
Specify the position for stapling. The number of sheets that can be stapled is 2 - 50 (when
80 gsm paper is used). Available paper types are: Plain paper, Recycled paper, Reload paper,
Bond paper, Heavyweight paper (106 - 169 gsm), Heavyweight Reload paper, Extra
Heavyweight paper (170 - 216 gsm), Extra Heavyweight Reload paper, Extra Heavyweight
Plus paper (217 - 220 gsm), Extra Heavyweight Plus Reload paper, Gloss paper (106 - 169
gsm), Gloss Reload paper, Heavyweight Gloss paper (170 - 216 gsm), Heavyweight Gloss
Reload paper, Extra Heavyweight Gloss paper (217 - 220 gsm), Extra Heavyweight Gloss
Reload paper, and Custom paper 1 to 5. If paper heavier than 90 gsm or lighter than 64 gsm
is used, outputs may not be stapled correctly even if the number of sheets is 50 or less.
Important • In the following cases, the actual stapling position differs from the stapling position displayed on
the screen:
- When [Original Orientation] is set to [Upright Images], and [Staple] is set to one position at the
right side.
- When [Original Orientation] is set to [Sideways Images], and [Staple] is set to one position at the
left side.
„
Hole Punch
Sets the position for punching.
The positions for punching vary depending on a finisher installed.
Important • When the punching feature of a finisher is defective, output is delivered to the center tray instead of
the finisher tray. Remove the output delivered to the center tray every now and then.
„
Original Orientation
Allows you to specify the orientation of the document so that the machine can identify the
top of the document.
Note • If the [Original Orientation] setting differs from the actual document orientation, the machine may
not detect the top of the document correctly.
z Upright Images
Select this option when placing the top edge of the document against the top side of the
document glass or document feeder.
z Sideways Images
Select this option when placing the top edge of the document against the left side of the
document glass or document feeder. Always select [Sideways Images] when the top of
the document is placed facing the left side (horizontal text).
„
Output/Offset
Allows you to select the output destination tray and offset operation.
z Offset Stacking
This option is displayed when you select [Center Tray - Upper] or [Center Tray - Lower] for
the output destination.When an optional finisher is installed, this option is displayed
when you select [Center Tray] or [Right Middle Tray].
The offset is a function for slightly offsetting and outputting each paper stack to allow
you to distinguish the separations. You can select from [Offset per Set], [Offset per Job],
[Offset Every N Pages], [Offset Every N Sets], and [System Default].
Note • This feature does not appear for some models. An optional component is required. For more
information, contact our Customer Support Center.
• If you select [System Default], the setting in the System Administration mode will be effective. For
information on how to change the setting, refer to "5 Tools" > "Copy Service Settings" > "Copy
Defaults" > "Output Destination" in the Administrator Guide.