Fuji Xerox DOCUCENTRE-II C3000, User Manual

Page: 56 / 603

3 Copy
54
Copy
3
„ Copy All X-Y%
The length and width ratios are set automatically to match the paper size and the
document is copied at a slightly reduced size to prevent image loss at the edge of the
original. If this option is selected, a check mark is added.
„ Width X% / Length Y%
Set the length and width ratios within the range from 25 to 400% in 1% increments.
„
XY
You can simultaneously change the numerical values of the height and width by the
same amount.
When [Calculator %] is Selected
You can specify a different size for the length and width.
If you specify both the original document size and the copy size, the copy ratios for the
length and width are calculated automatically within the range from 25 to 400%
according to the sizes that you entered.
1
Enter the value for the original
document width in [Original Size] of
[X] (width) using the numeric
keypad, and select [Next].
2
Enter the value for the copy size
width in [Copy Size] of [X] (width)
using the numeric keypad, and
select [Next].
3
In the same way, enter the original document height value and copy size length value
in the [Original Size] and [Copy Size] of [Y] (length), and select [Next].
Note • To change the copy ratios you have entered, select [Next], move the mark, and enter the
new values.
„ X:width Y:length
The automatically calculated ratios based on the values entered in [Original Size] and
[Copy Size] are displayed.
„ Original Size
Set the length and width of the original size from 1 to 999 mm in 1 mm increments.
„ Copy Size
Set the length and width of the copy size from 1 to 999 mm in 1 mm increments.
Paper Supply (Selecting the Paper for Copying)
You can select the tray loaded with the copy paper you want to use.
1
Select the paper tray.