Fuji Xerox DOCUCENTRE-II C3000, User Manual

Page: 312 / 603

11 System Settings
310
Sy
st
em Set
tin
gs
11
Edge Erase - Left & Right Edges
Set the default value for the amount of edges erased from the original in the left and right
directions in [Edge Erase] in the [Layout Adjustment] screen. Specify a value from 0 to 50 mm
in 1mm increments.
Center Erase/Binding Erase
Set the default value for the binding erase amount of the original in [Edge Erase] in the
[Layout Adjustment] screen. Specify a value from 0 to 50 mm in 1 mm increments.
Image Compression
Set the default value for [Image Compression] in the [Output Format] screen.
Scan-to-FTP/SMB Defaults
You can select the default protocol (transfer protocol) used for transfer from FTP, SMB,
and SMB (UNC Format).
Original Size Defaults
Set the original size shown in [Original Size] in the [Layout Adjustment] screen. An
original size is assigned to each of the 11 buttons other than [Auto Size Detect].
When frequently scanning non-standard size originals, by presetting the non-standard
size, you can save time to enter the original size each time a document is scanned.
„ A/B Series Size
Select from 10 sizes of A and B series.
„ Inch Size
Select from 12 sizes of inch series.
„ Others
Select from other 13 sizes.
„ Variable Size
You can enter any size. Set the width (X) from 15 to 432 mm, and the height (Y) from 15 to
297 mm in 1 mm increments.
Output Size Defaults
Set the sizes to be displayed at [Output Size] when selecting [Auto %] for scanning
documents at [Reduce/Enlarge] in the [Layout Adjustment] screen.
Any output sizes can be assigned to output size buttons 1 to 8.
By setting the commonly used sizes, you can reduce the number of selection operations for
scanning.
„ A/B Series Size
Select from 10 sizes of A and B series.
„ Inch Size
Select from 12 sizes of inch series.
„ Others
Select from other 13 sizes.