Fuji Xerox DocuCentre 1055, User Manual

Page: 193 / 245

Troubleshooting Tables
193
Troubleshooting Tables
If you are experience difficulties using the machine, check the suggestions in the
following tables for advice. If this does not remedy the problem, refer to
Fault Clearance
Procedure on page 183 .
Symptom Recommendation
The machine will not power on. • Check the power cord.
• Check that the power switch is pressed to
the <I> position.
• Check that the <RESET> button on the
side of the machine is not in the tripped
(popped up) position. Push the button to
reset.
• Check that the AC outlet is supplying
voltage. Connect another appliance to the
outlet to verify the voltage supply.
The error indicator lights. • Check whether a message is displayed on
the screen. If a message is displayed,
follow the instruction of the message. If
not, press the <Machine Status> button,
and select [Error Information] to check the
contents displayed on the screen.
The machine makes a squealing noise after it
powers off. • Between 3 to 5 minutes after powering off,
the machine may make a squealing noise.
This is not cause for concern, since
various components within the machine
are still powering off.
The document will not feed through the
document feeder. • Check that the document feeder is not
overloaded. The document feeder can
hold a maximum of 50 sheets.
• Check that the document is fully inserted
into the document feeder.
• Using a lint-free cloth, lightly wipe the
platen cushion on the underside of the
platen cover.
• Set the document, and then check that the
side guides are not too tight.
The machine does not display one of the
paper trays as one the Paper Supply
selections. • Check that no paper trays are open. If a
tray is ajar, the machine cannot sense its
connection.
• Open and close each paper tray. If this
does not rectify the problem, then power
the machine off and then on.