Fuji Xerox DocuCentre 1055, User Manual, Page: 168 / 245

9 Setups
168
Delete
Select when deleting the registered Speed Dial.
*1:You can also use symbols as well as text and numbers.
Select [Alphabet] for Entry Mode, press the <# > button to display a list of symbols, then
select a symbol using the <Select> button.
Fax Program
This feature allows you to program information about the fax destination and the
features used to send fax. You can always send faxes using the same conditions of
transmission by recalling the program using One Touch Dial or Speed Dial. In addition
to the information of the fax destination, you can program the following three types of
program. Fax Send, Poll (Polling) Receive, and Post Send that transmits more than one
document at a specified time.
NOTE: If the destination registered to the
Fax Program under a Speed Dial code is
changed to an e-mail address, a
transmission error will be issued when a
message is sent to that destination.
1.
Select a program number (p01 to p30) selecting [ ] or [ ] using the <Select>
button, or select to search a program number using [By Program No.].
2.
Press the <Enter> button.
3.
Perform the necessary operations.
Program Name
*1
Enter the program name. Select [Edit] to display the Program Name entry field screen,
select [Entry Mode] to switch the character type and enter the name using the
alphanumeric keypad on the control panel.
To change the name, press the <C> button to delete the entered name, and then enter
the new name.
Index
Enter the index used to search the program name in Address Book.
To change the index, press the <C> button to delete the entered index, and then re-
enter the new name.
Program Type
Select the type of the program.
NOTE: The feature that can be programmed differs according to the type of the
program.
Fax Send – Set the [Resolution] and [Scan Size], etc., to send a fax. For each feature,
refer to
Fax Features in the Fax chapter on page 71.